Mount the module – Rockwell Automation 1440-TTC06-00RE XM-362 Isolated Temperature Module User Manual
Page 6
6
Rockwell Automation Publication ENMON-IN360F-EN-P - February 2014
XM-360 Process Module, XM-361 Temperature Module, and XM-362 Isolated Temperature Module
Mount the Module
The XM® 360, XM-361, and XM-362 modules mount on a XM-944 terminal base unit, catalog number1440-TB-E. We
recommend that you mount the modules after you have connected the wiring on the terminal base unit. Refer to the
XM-944 Process/Temperature Terminal Base Installation Instructions, publicatio
he module user
guide for the specific module for wiring information.
1. Make certain the keyswitch (A) on the terminal base unit (C) is at position 5 as required for the modules.
2. Make certain the side connector (B) is pushed all the way to the left.
You cannot install the module unless the connector is fully extended.
3. Make sure that the pins on the bottom of the module are straight so they align properly with the connector in the
terminal base unit.
4. Position the module (D) with its alignment bar (E) aligned with the groove (F) on the terminal base.
5. Press firmly and evenly to seat the module in the terminal base unit.
The module is seated when the latching mechanism (G) is locked into the module.
6. Repeat the above steps to install the next module in its terminal base.
All grounds in the system must be tied to the same point of the same grounding electrode system.
Maintain a 2.54 cm (1 in.) minimum clearance between the module and adjacent equipment. There are no orientation
restrictions.
ATTENTION: The XM-360, XM-361, and XM-362 modules are compatible only with the XM-944 terminal base unit. Verify
that the keyswitch on the terminal base unit is at position 5 for the modules.
Do not attempt to install the XM-360, XM-361, and XM-362 modules on other terminal base units.
Do not change the position of the keyswitch after wiring the XM-944 terminal base unit.