AJA FS1-X Manual - Manual (Page 25)

FS1-X v1.1 www.aja.com 25
SDI In/Out Digital video with embedded audio. Two SDI input and two SDI Output BNCs. 10 bit 3G/
HD/SD SDI is supported.
HDMI In/Out HDMI In and Out is supported on HDMI connectors. Standard SD and HD video formats
are supported, including support for 8 channel embedded audio. Also supports standard
computer DVI video formats (input via a DVI to HDMI cable). HDCP (copy protected)
HDMI video is not supported.
Component In/Out YPbPr/
RGB Video
Component Analog Video is supported on 3x BNCs for Input and Output. Video A/D and
D/A converters are 12-bit and support both SD and HD. YPbPr format is supported or the
outputs can be switched to RGB.
NOTE: Unlike the other connectors, the set of three Component input connectors and the single
Composite analog video input connector cannot be used simultaneously. You can choose
either Component or Composite input, but not both. The same source video is also sent to
both sets of analog video outputs.
Composite In/Out Composite NTSC or PAL standard definition Input and Output. Composite Video A/D and
D/A converters are 12-bit.
Ref Loop The Reference Loop BNCs accept an Output timing reference signal. The reference can be
SD Blackburst or HD tri-level sync. Examples of permissible reference video input signals:
• 525 Color Black
• 625 Color Black
• 1080i Tri-level Sync
• 720p Tri-level Sync
The 2 BNCs are a passive loop: one BNC is for the Input, and the remaining BNC can be
connected to another piece of equipment in the reference chain or terminated.
NOTE: For proper operation the input Reference signal must be stable and properly terminated using
a 75-ohm terminator on either the unused loop connector or the last piece of downstream
equipment to which the Ref Video is connected.