AJA FS1-X Manual - Manual (Page 99)

FS1-X v1.1 www.aja.com 99
System Name
The System Name parameter sets the name of the FS1-X system. To change the System
Name, click on and drag the cursor across the displayed name, and type in a new name.
SNMP Parameters
The following parameters are used to setup the FS1-X SNMP (Simple Network
Management Protocol) feature.
• SNMP Enable
• SNMP Trap Dest 1
• SNMP Trap Port 1
• SNMP Trap Dest 2
• SNMP Trap Port 2
In addition, the following alarms may affect SNMP messages:
• Power Supply Alarm
• Video1 Format Alarm
• Video 2 Format Alarm
• Reference Alarm
Refer to "Chapter 6: SNMP on page 108" for a description of SNMP and how the FS1-X
supports it.
Hidden Menus
This selection lets you choose whether to hide or show inactive menus.
Display Intensity
Display Intensity determines alphanumeric display and front panel LED brightness.
UPnP Host
UPnP Host enables the FS1-X to be discovered by a Windows network.
When this parameter is enabled, you can view the FS1-X on a Windows Network by
clicking these selections in Windows 7: Start > Computer > Network (in left pane). Any
FS1-Xs on the network will be listed under Other Devices below Computers and Media
Devices. If your system does not have network discovery enabled, you may need to
enable it following the Windows help instructions to make network devices visible in the
Windows Network window.
Variable Highlight the existing name and type in a new name, up to 20
characters. Allowed characters are A-Z, a-z, numerals, hyphen,
and period.
Hide Inactive (default)
Show All Hides menus that are not in use.
Shows all menus, even those that are not in use.
Variable Use the slider to dim or brighten the alphanumeric display and
activity indicator LEDs in steps from 1 (dim) to 8 (brightest).
Default is 6
Enable (default)
Disable Enables the FS1-X to be discovered by a Windows network.
Disables Windows network discovery of the FS1-X.