AJA V2Digital - Manual (Page 6)

V2Digital v1.0 www.aja.com 6
External DIP
Switches
The V2Digital has a 4-switch DIP accessible through a cut-out in the bottom of the unit.
For specific DIP switch setting information, see
“DIP Switch Settings” on page 7 .
MiniConfig Control
MiniConfig is an AJA application used for configuring and updating the firmware of
several AJA products. Configuration set via MiniConfig is stored in the unit through
subsequent power cycles. See
“USB Control and Setup—Using AJA MiniConfig” on page 8 .
Installation
Typically, V2Digital installation consists of the following:
1. Disconnect power from the converter.
2. Configure the DIP switches for the desired equipment configuration and video
formats.
3. Connect video equipment to the convertor BNCs.
4. Apply power to the converter (AJA power supply included).
Alternatively, you can set the unit to Remote operation using DIP switch 1, connect the
unit to a PC or Mac via USB, and then use MiniConfig to configure the unit. The
MiniConfig application is available for download from the AJA website.
NOTE: Threaded holes (unified 4-40) located on the bottom of the unit can be used for mounting.
Specifications
Formats: • 525i/625i, 1080i 50/59.94/60 Hz
• 1080psf 23.98/24/25/29.97/30 Hz
• 720p 50/59.94/60 Hz
Inputs: • HD component YPbPr, RGB (274/296M), 3 x BNC
• SD component (Betacam, EBU-N10)/composite/ YC(S-Video), 3 x BNC
Outputs: • HD/SD-SDI (SMPTE-259/292M), 1 x BNC
User Controls: • Configuration via USB with MiniConfig for Mac or PC
• External DIP switch
• Control (Local/Remote)
• Component/Composite (SD Only)
• Format SD only (YPbPr/YC)
• Format HD only (YPbPr/YC or RGB)
• Pedestal Present (on/off) (SD Only)
Physical: 5.1” x 2.4” x 1” (130 x 61 x 25 mm)
Power +5-20 VDC, 4 watts