Antelope Audio Trinity Master Clock - Manual (Page 14)

INSTALLATION AND CONNECTION
1. Before placing the device into its operating location, consider the following:
To minimize frequency instabilities, the device should not be placed near equipment
generating strong magnetic fields, such as generators, transformers, etc.
To prevent possible interference, observe a minimum distance of 5 centimetres (2
inches) between the cables of this device and any non-coaxial audio cables.
It is to use the device unmounted (i.e. not in a rack) as long as the above
conditions are met. There is no requirement for the device to be levelled horizontally
2. If the DC Power Connection is to be used, make sure the power is wired
properly, because reversed polarity may damage the device. Refer to the illustration
below for information on how to make the connection. If in doubt consult a competent
technician.
all right
cable
3. Mount the device on its operating place in the rack and secure it with screws.
4. Connect the AC Power Connection and/or the DC Power Connection to the
respective power outlet(s).
Note: When connecting devices, do so with the studio volume turned down as some devices
may emit an unpleasant sound until properly configured to accept incoming clock.
Connect to the following mark on the
power supply unit circuit board / terminal:
+12 V
Ground
Earth
(optional, use it if available on the power
supply unit)
If the mark on the
Speakon NL4FX plug is…
1+
2 -
1 -
13
19
19 18