Antelope Audio Trinity Master Clock User Manual
Page 8
6
8
9
10
.
AUDIO Channel Edit Select Buttons
7.
Triple Display
.
DIMMER Knob
.
HD Select Encoders
.
VARISPEED Select Button
11.
SPLIT Mode
These three buttons are used to select the audio channels for editing, and can be
edited individually or all at the same time which, if editing all can give you a big single
channel master clock utilizing all rear panel outputs. If pressed once from standard
mode the current state of the channel(s) will be visible, including varispeed and pull
ups/pull downs.
Displays information for everything except HD.
Adjusts the brightness of the triple display.
Use these knobs to select HD rates for the three HD channels. Press to confirm a
change.
HD1, HD2, HD3 signals are sent to the corresponding rear panel output BNC
connections
.
Press this button when editing an audio channel allowing varispeed adjustment via
the SAMPLE RATE encoder knob (4). The VARISPEED button toggles between
adjustment options of cents and percent, where a 'c' on the display signifies cents
mode, and a 'p' on the display signifies percent mode. Press SAMPLE RATE
to confirm varispeed setting.
Once any channel has been saved with a varispeed setting, the varispeed
indicator will always light when NOT in edit mode to show that one or more
channels is using varispeed.
The reasoning behind this function is to avoid TRINITY mis-locking to an input
frequency that is non-standard, but very close to a standard gearboxing frequency.
(See standard gearboxing frequencies in Appendix A).
If you know that your input
frequency is a non-standard, non-gearbox frequency, then use SPLIT mode to allow
DA of this non-standard input.
For this function to have any effect, at least one audio channel must be in DA
mode. If no audio channels are in DA mode, and SPLIT is activated, the input
will be ignored. When SPLIT is activated, the audio channel(s) that is/are set to
DA will
lock to the SOURCE signal. All channels not in DA mode will
continue to generate the frequency displayed for the respective channel(s), and
will be running on internal oven or external Atomic.
Note:
Note:
In edit mode, pull ups/downs are not only shown with lights
&
, but are also shown
with dashes after the frequency on the main display. So, If 0.1% & 4% pull ups are selected, the
middle and top line of the last digit on the display are lit. If 0.1% & 4% pull downs are selected,
the middle and bottom line of the last digit in the display are lit.
The SPLIT button has no function when SOURCE is set to VIDEO or OVEN.
knob
NOT
This is an advanced function, and to be used only if receiving a varispeed
signal on the input. Using SPLIT will likely cause synchronization errors if
used when the input
a standard gearboxing frequency. SPLIT mode disables
gearboxing for any channels that are set to DA while in SPLIT mode.
IS
7
12
13
35
4
4