Atomos Ninja Blade - Manual (Page 16)

Atomos Ninja Blade – User Manual Edition 1: Feb 2014 14
Audio In
Located in the bottom left corner of the main screen you can see the
Audio Monitoring Levels, with access to
Audio in
.
You can see 2 digital channels (via HDMI input) and 2 analogue audio
channels (via the Stereo Line in). Each channel has a small rectangle
assigned to it; when there is active sound coming in you will see the level
indicator moving.
Any rectangle shown in orange is set to be recorded. To change the
record settings, adjust the gain of Analogue audio in or headphone output
levels and monitor selection access the menu
When you touch the Audio in access icon you are taken to the Audio In
Page, where you can choose to record from either or both of the digital
HDMI and analogue inputs. Underneath each pair of audio channels you
can see the R record button, when this is shown in red it is set to record,
simply select all you want to record.
You can adjust the analogue audio gain by pressing the + and - buttons
next to the channel pair. There is also a slider to control the line out level.
Press any point along the line or slide your finger to the left or right to
adjust.
It is not possible to vary the gain if the signal input is from the HDMI
connection because this is digital and is embedded in the signal.
You can usually adjust this from the camera, please see your
camera manual for operational details.
AUDIO DURING PLAYBACK MODE
When you enter into Playback mode on the Ninja Blade it will only output
channels 1/2 on the headphones, please bear this in mind when you
select the audio channels for recording.
7. Using the Ninja Blade
cont.