AudioEngine N22 DESKTOP AUDIO AMPLIFIER - Manual (Page 5)

Step 3 – Connecting the Power Supply
Be sure that the volume/power switch on the front panel is in the OFF
position by rotating it counterclockwise until you hear a click.
Connect the cable with the round end from the power supply to the N22 rear
panel power connector. Note that this connector is “keyed” so line up the
arrow on the cable end with the arrow on the rear panel. Please do not use
excessive force on the connector and use only the power supply provided
with the amplifier.
Connect the AC power cable from the power supply to a power outlet and
verify that the indicator light on the power supply is illuminated. We
recommend using a high-quality surge suppressor and/or AC line filter on all
electronics equipment.
Step 4 – Connecting Audio Sources
Using the appropriate audio cable (3.5" mini-jack and/or RCA cable),
connect your audio source (computer, iPod, etc.) to the N22 audio inputs.
One of each cable type is included with your amplifier.
Step 5 – Operation
Turn on the N22 volume/power knob and set the volume control to an initial
setting of about 3 o’clock. The front panel power indicator will be
illuminated.
Turn on your audio input source and adjust the volume to your desired
listening level.
Note that both audio inputs on the N22 are active so two audio sources may
be connected to the amplifier at the same time without the need for an
input switch. We recommend using the volume control on each audio
source to adjust the overall system volume.
5 6 audioengine N22 setup guide audioengine N22 setup guide


Using Bare Wire
 Use your thumb and finger to unscrew the
binding post connectors on the back of each
speaker.
 Insert each speaker wire into the holes on the
side of the binding post connectors, observing
proper polarity.
 Retighten the binding posts with your fingers.
 The stripped portion of the wire should be
secured firmly in each connector.
 Make sure that none of the speaker wire strands
have come in contact with an adjoining terminal.
 Repeat steps 1 and 5 to connect speaker wires to
the amplifier.
L R
L R
A
B
INPUTS
LINE OUT
USB POWER
POWER
OUTPUT L
OUTPUT
R
Made in China Intertek 3056826
CONFORMS TO UL STD 60065 CERTIFIED TO CSA STD C22.2 No. 60065
Left Speaker Right Speaker
Speaker Connections