Autocue SSP10 Portable - Manual (Page 2)

Assembly
2. Fix the hot shoe from your
tripod to the underside of the
mounting plate. Slide the hot
shoe to the approximate
position and tighten the
screws. Components
A
Hood and
Glass
B
Monitor
C
Mounting
Plate
D
Hood
Adjustment
Screws
D
C
A
B
3. Mount the unit on
the tripod and raise
the hood to the upright
position
Mounting the Camera
2. For smaller cameras the camera plate will need to
be raised. Remove the four thumb screws and lift off
the plate.
3. Install four camera
plate pillars of the
appropriate height.
4. Re-fix the camera
plate using the four
screws provided.
Pillar combinations
To achieve the maximum
height, combine two pillars.
4. Move the hood up
and lock into position
by tightening the four
thumb screws
(B)
1. For larger cameras the mounting plate may
need extending. Loosen the four thumb screws on
the camera plate and remove the rear two, the
plate will now slide out. Replace the two rear
screws and tighten them to secure
the plate.
1. Loosen the thumb
screws
(A) and move
the monitor into the
horizontal position .
Re-tighten the monitor
thumb screws.
A
B
Pillar Kit
Unit Complete
Hood Lock