Autocue SSPi - Manual (Page 2)

Assembly
A
B
C
D
E
G
F
1. Remove the unit from its case
and carefully place the glass
side face down, onto a level
surface.
2. Loosen the thumbscrews holding the iPhone
carrier mounting plate and raise the iPhone carrier.
3. Align the metal tongue of the iPhone carrier
plate with the slot in the drop bracket and carefully
insert the tongue into the slot. (fig. i)
4. Tighten the thumbscrews to secure the iPhone
carrier mounting plate. (fig. ii)
5. Attach the tripod camera mounting plate
to the hot shoe plate on the underside of
the SSPi unit.
6. Slide the on-camera
unit onto your tripod.
7. Loosen the two thumbscrews
holding the iPhone carrier mounting
plate and hood assembly.
8. Raise the hood assembly to
the vertical position and tighten
the thumbscrews.
9. Rotate the camera bracket so that it is on the
top of the unit and behind the hood.
Components
10. Fix your camera to the bracket using the
camera screw. Slot the bracket over the
thumbscrews and tighten all four thumbscrews to
secure it.
11. Fit your iPhone into the iPhone carrier by
loosening the knob on the underside. Slide the
two components apart, then close ensuring the
corners of the iPhone are held securely by the
carrier.
A Hood and glass
B iPhone carrier
C Hood Bracket
D Camera Bracket
E Hot Shoe Plate
F Drop Bracket
G Carrier
mounting plate
H Hood
thumbscrew
I Hood Slide
Screw
fig. i fig. ii
H
Vertical position
I