Autocue QBox Installation Guide - Manual

QMaster - QBox Installation Guide
Ethernet
PC with
QMaster
software
QBox
On Camera Monitor
Composite Video (BNC)
QBox Setup Diagram
Scroll Control
1. Set up the equipment as shown in the diagram
(Power connections not shown for clarity).
Network:
Connect the QBox to your network using a network patch cable. Your PC will also connect to
the network. A small hub or switch will work if no other network is available.
Note: Connecting the QBox directly to your PC via a network cross-over cable is not officially
supported.
Video: Connect the QBox to the on camera monitor via any one of the composite video (BNC)
outputs.
Scroll controller: The scroll control(s) can be connected to the QBox or the PC. Connection to
the QBox is recommended. Controller options are explained in more detail in step 4 below.
Keyboard: Temporarily connect a USB or PS/2 keyboard to the QBox. This is required for
QBox configuration. Once the configuration is complete, you may unplug the keyboard.
Power: Connect the power adapter to the QBox. To turn on the QBox, push the power button.
When the QBox is done booting up, you will see a small white triangle in the top left corner of
the monitor. This is the cue marker.