Autocue QBox Installation Guide User Manual
Page 10
QMaster will monitor and use all controllers that are connected to the QBox and the PC, as
long as they have been properly configured.
Controller configuration:
To configure scroll controls connected to the PC:
Go to Tools->Options->QBox Prompt Engines-> Scroll Controls.
To configure scroll controls connected to the QBox:
- For version 1 QBox, right-click on the QBox in the QBox status panel, then select
“Device Settings…”. If using a serial controller, go to the ‘Serial Scroll Controls’ tab. Add
the appropriate controller, and select Com1.
Go to the ‘Configure scroll controls’ tab. Highlight the appropriate controller. Click on
Setup button to configure. The default options are usually correct. Only change them if
necessary.
- For version 2 QBox, go to Prompt->QBox Manager. You will need to log into the QBox.
Username=qbox, password=qbox. Some controller types require that you define the
controller you have under the ‘Hardware Ports’ section. Controller configuration is done
under ‘Scroll Controls’. The default options are usually correct. Only change them if
necessary.
A QBox restart is necessary after making scroll control configuration changes.
Note: The wireless mouse hand control can only be connected to the QBox.
Wireless Mouse Hand Control
Closed Captioning (Optional):
Follow instructions here