Autocue HPS-120 - Manual (Page 10)








10
4.3.2. Command List for Remote Device
To change the configuration for a remote device via over-the-air, firstly you have to use a
command “O” at the local device. The following are a procedure for changing configuration of
remote device via over-the-air.
z Configure a remote device at the local device.
z Save changes at the local device.
z Make a connection between the local device and remote device (Automatically).
z Send changes from the local device to the remote device (Automatically).
z Apply changes at the remote device and reboot (Automatically).
Item Syntax Description Remarks
1. Connecting
address
A Addr<Enter> Set a connecting address for
remote device.
2. Baud rate B Baud Rate Change the baud rate for the
remote.
3. COM port C COM Port This is only valid in mode 2.
4. PIN code E PIN<Enter> Authentication Off: Type <Enter>
Authentication On: Type up to 11
characters
Paired adapters should
have a same PIN code.
5. Flow control F Flow Control Set the Flow control for remote.
6. Connection
mode
M Mode Set a connection mode for
remote.
7. Friendly name N Name<Enter> Set a friendly name up to 11
characters for remote.
8. Parity Bit P Parity Set the parity bit. 0: None, 1: Odd 2: Even
9. Stop Bit S Stop Set the stop bit. 0: 1 Stop, 1: 2 Stop
10 View V Display configuration
information for remote
11. Exit X Save changes and return to
main menu.
12. Usage ? Print the usage.
Remarks1: To configure a remote device via over-the-air, a local device must be able to make a
connection to the remote device.
Remarks2: You can change a PIN code for the remote and local device as follows:
Change a PIN for remote at the local -> Apply it. -> Change a PIN for local and apply it.
Remarks3: Once you change a connecting address, and connection mode for the remote, the
local device won’t be able to make a connection to the remote device.