Behringer EUROPOWER PMH660M - Manual (Page 10)

10
EUROPOWER PMH660M/PMH880S
5. WIRING EXAMPLES
For stereo operation the POWER AMP switch of the
PMH880S must be set to its upper position (MAIN L/MAIN R). Outputs
A and B deliver the stereo main signal to the P.A. speakers. Two
active speakers, wired in parallel, are connected to the PREAMP
MONITOR output. They are used as on-stage monitor speakers.
The effects processors can be switched on and off with a dual
footswitch. This set-up is not possible with the PMH660M (no
stereo operation possible).
Fig. 5.1: EUROPOWER mixer as a stereo amplifier
(example)
5. WIRING EXAMPLES
Both the PMH880S and the PMH660M can be set-up for dual
mono operations. The POWER AMP switch must be set to its
lower (PMH660M) or center position (PMH880S). The two
loudspeaker outputs provide the main and the monitor signals
independently of each other and to two loudspeakers each,
which are wired in parallel.
Fig. 5.2: EUROPOWER mixer as a dual mono amplifier
(example)