Behringer EUROPOWER PMH660M - Manual (Page 8)

8
EUROPOWER PMH660M/PMH880S
4. INSTALLATION
SPACE RADIO: Here, the typical sound of scanning an FM
tuner is simulated. This can be a very interesting effect when
sound-tracking radio plays.
TEST TONE: Use this 1-kHz test tone to facilitate P.A. level
setting.
4. INSTALLATION
4.1 Mains connection
Blown fuses must be replaced by fuses of the same type and
rating.
The mains connection is made using the enclosed power cord
and a standard IEC receptacle. It meets all of the international
safety certification requirements.
+
Please make sure that all units have a proper
ground connection. For your own safety, never
remove or disable the ground conductor from the
unit or of the AC power cord.
4.2 Audio connections
The inputs and outputs of the BEHRINGER EUROPOWER are
unbalanced 1/4" TS connectors—except for the balanced mono
line inputs. Of course, all inputs and outputs work with both
balanced and unbalanced connectors. The Tape Ins and Outs
are on stereo RCA connectors.
+
Please ensure that only qualified personnel install
and operate the power mixer. During installation
and operation, the user must have sufficient
electrical contact to earth. Electrostatic charges
might affect the operation of the unit.
Fig. 4.1: 1/4" TS connector
Fig. 4.2: 1/4" TRS connector
Fig. 4.3: XLR connectors
Fig. 4.4: 1/4" TS connector for footswitch
+
Please use a dual footswitch for the PMH880S, so
that you can enable/disable FX1 and FX2
independently of each other. In this case, the tip of
the 1/4" plug controls FX1, and the ring FX2.
Fig. 4.5: RCA cable
4.3 Loudspeaker connection
Your EUROPOWER is equipped with high-quality NEUTRIK ®
SPEAKON ® -compatible loudspeaker connectors, which ensure
safe and trouble-free operation. The SPEAKON ® connector was
especially developed for high-power loudspeakers. Once it is
plugged in, it safely locks into position and cannot be accidentally
disengaged. It prevents the occurrence of electrical shock and
ensures the correct polarity. Each of the connectors carries
only the assigned single signal (see tab. 4.1/fig. 4.7 and the
information on the rear panel of the power mixer).