BenQ AWL-100 - Manual (Page 13)

BENQ Corporation 9
Current Tx Rate
This field shows the current transmit rate, which is being used for an active
connection.
Current Channel
This field shows the current radio channel, which is being used for an active
connection.
Throughput
The instantaneous wireless Receive and Transmit throughput are displayed in bytes
per second in this field. Every two seconds, these values are updated.
Link Quality
This field reveals the quality of the current connection. Only when the node is in
Infrastructure Mode does the Link Quality bar graph become active. The bar graph
displays the link quality between the node and its Access Point. Over the bar graph, a
label summarizes the quality of the link, which can take on one of the following
values:
“Not
Applicable”
“Poor”
“Fair”
“Good”
“Excellent”
When the Link Quality becomes “Poor,” the driver will start to look for a better
Access Point. As a result, the Link Quality is a very good indicator of receiving and
transmitting errors over the radio.
Signal Strength
The Signal Strength bar graph only becomes active, when the node is in
Infrastructure Mode. This bar graph shows normalized signal strength as reported by
the radio, averaged over all frames over 100 bytes long, which are received from the
Access Point.
Status information about the radio link is displayed in this tab. Detailed description
should be placed in this field.