Bang & Olufsen BeoCord V8000_MS - User Guide - Manual (Page 11)

11
What’s on the TUNING menu…
FREQUENCY
Indicates the frequency of a station. Searching
stops at the first station producing an acceptable
signal. If this is not the station you want, just
continue searching. If you wish, you can key in the
exact frequency of a station instead, using the
number keys on Beo4.
PROGRAM
Indicates the staion’s program number. 59
program numbers are available on which you can
store TV stations.
FINE (Fine tuning)
Indicates fine tuning – usually fine tuning is not
required because the best possible picture is
always selected. However, neighbouring channels
may blur the picture slightly, in which case, fine
tuning may be necessary. You can fine tune
within a range of +8 – -8.
SUBTITLES
Indicates the Teletext subtitles page. Key in the
number of an appropriate Teletext subtitles page
to include subtitles when you record from a
particular station. (Teletext pages 100-899 are
available)
Note: If you no longer wish to include the
subtitles for a station then key in the number of a
Teletext page which is not a Teletext subtitles
page.
(SYSTEM)
This item is only available on a multi-standard
system. A range of options are available: BG, L, I,
and DK are available. Only selected options will be
available for certain systems. Check that the
correct broadcast system is displayed, before you
start tuning.
SOUND
Indicates the type of sound you choose to store
for a specific program number.
STEREO… Indicates that stereo sound will be se-
lected for a program number or that the best
possible sound or sound quality will be selected.
MONO… Indicates that mono sound will always
be selected.
Clearing a stored station…
If you wish to clear a stored station, then:
• Call up the tuning menu
• Move to the item PROGRAM and select the
program number you want to clear
• Now press 0 to reveal CLEAR instead of
PROGRAM
• Finally, press GO to store your entry and
clear the station. (If you should wish to
keep the station, press STOP instead of GO).
To leave the menus, press EXIT.