Bang & Olufsen BeoVision Avant (1995-2005) - User Guide - Manual (Page 62)

B E O V I S I O N A V A N T S U R R O U N D S O U N D
62
BeoVision Avant as a surround sound AV system
If your BeoVision Avant is equipped
with a surround sound module, you
can extend your system into a fully
equipped surround sound audio and
video system by connecting four active
Bang & Olufsen loudspeakers and a
Bang & Olufsen audio system* to the
BeoVision Avant.
The BeoVision Avant built-in speakers
will be used as a centre speaker in the
surround sound system.
Using your AV system…
If your BeoVision Avant is set up as a
surround sound system, just choose the
source you wish to hear or see.
It is also possible to record audio
sources on the video recorder or vice
versa if an audio tape recorder is
available. Simulcast audio and video
transmissions are also possible, you can
even record the experience on the
video tape recorder.
In a surround sound AV system, all your
Beo4 remote control commands must
be directed to the BeoVision Avant.
*Note: To display AV on Beo4, you must add the
function to Beo4. Please refer to page 67 for
further instruction.
A BeoVision Avant surround sound system can be
extended with a compatible Bang & Olufsen
audio system, turning your setup into a fully
integrated surround sound AV system.
Please note…
The surround sound module is available as an
optional extra for the BeoVision Avant.
Please contact your Bang & Olufsen dealer for
further information.
TV
7
then
RECORD
RECORD
then
RADIO
9
then
RECORD
RECORD
then
TV
then
RADIO
then
RECORD
RECORD
LIST
GO
LIST
GO
LIST
GO
Record sound from a video source on your audio
tape recorder…
Select e.g. TV program number 7
Press LIST until AV* is displayed
Press GO to activate the audio/video
function
Press to start the actual recording on
the audio tape reocorder
Record sound from an audio source on your video
tape recorder…
Select e.g. RADIO program number 9
Press LIST until AV* is displayed
Press GO to activate the audio/video
function
Press to start recording on the video
tape reocorder
Watch a TV programme and listen to the same
programme on the radio…
Press TV
Press LIST until AV* is displayed
Press GO to activate the audio/video
function
Press RADIO
To record it onto the video tape recorder…
Press to record the simulcast
transmission
To stop any of the recordings, press V TAPE or
A TAPE, and then STOP twice…
*Note: Not all types of Bang & Olufsen audio
systems support audio/video integration with the
BeoVision Avant. Please contact your Bang &
Olufsen dealer for further information.