Bang & Olufsen BeoVision MX_4200 - User Guide - Manual (Page 44)

44
Set up your television
For information about how to fasten
and run the cables on the rear of the
television, refer to the opposite page.
For further information about the
close-up operation and socket panels,
refer to pages 45–46 and 48–49.
The television can also be placed on the floor, in
an upright position or at a slight tilt backwards.
Place your television in your home
– Avoid placing your television in direct
sunlight or direct artificial light, such as a
spotlight, as this may reduce the sensitivity
of the remote control receiver.
– Make sure that the television is set up,
placed and connected in accordance with
this Guide.
– The television is developed for indoor use
in dry, domestic environments only, and for
use within a temperature range of 10–40°C
(50–105°F).
– Do not place any items on top of the
television.
– Do not attempt to open the television.
Leave such operations to qualified service
personnel.
– Always place your television on a firm and
stable surface. If placed on a soft, heavy
carpet, it must be duly protected against
overturning.
– If your television is placed on a Bang &
Olufsen stand with castors, it must always
be moved with the utmost caution. Special
care must be taken when the television on
its stand is moved over uneven surfaces or
obstacles, such as a carpet or cable on the
floor.
– Allow a space of at least 5 cm above and to
each side of the television for adequate
ventilation.
The following specially-designed stands and wall
brackets are available for placement of your
television:
– Stand type number 4088
– Wall bracket type number 4114
– Motorised wall bracket type number 4089
Do not attempt to place your television on any
other stand or wall bracket than those listed
above! Contact your Bang & Olufsen retailer for
further information.
If you have a motorised wall bracket, leave
enough space around the television to allow it to
turn freely. The television can also be turned by
hand.