Brinkmann ProSeries 7751 - Manual (Page 26)

25
Step 3
Remove rotisserie burner cover
from rotisserie burner assembly.
The bolts and washers removed
will be used again in Step 6.
Step 4
Insert the thermocouple bracket
through the hole in the back panel.
Secure bracket to back panel using
three M4 X 8mm bolts, M4 lock
washers and M4 nuts.
Step 5
Attach gas supply line to pre-installed
rotisserie burner orifice using two
M4 X 8mm bolts as illustrated.
Step 6
Replace rotisserie burner cover over
rotisserie burner assembly and
secure. Make sure rotisserie ground
wire is inserted under one of the
rotisserie burner cover bolts for a
proper ground.
Step 7
Attach the rotisserie burner electrode
wire to the igniter module located
inside the right door. The connection
should be made to the only open
terminal.
Step 8
Place hood on the grill and align with
holes, then secure hood with hood
bolts and cotter pins as shown.
Electrode Wire
Igniter
Module
Hood
Cotter Pin
Hood Bolt
Battery Compartment
Location of
Rotisserie
Burner Igniter
Burner
Orifice
Gas Supply
Line
Rotisserie
Burner Cover
Ground
Wire
M4 X 8mm
Bolts
Thermocouple
Wire
Thermocouple
Bracket