Bang & Olufsen BeoLink Active - Setting-up Guide - Manual (Page 6)

6
Cables should always be handled with great care. When
running the cables, avoid bending them too sharply and
be careful not to twist them. Avoid subjecting the cables
to pressure or impact.
Using the cable supplied, connect the BeoLink Active
receiver as follows:
1 Detach the rear cover of the BeoLink Active receiver
(unscrew the two screws (C) and loosen the two screws
(D), then lift off the cover).
2 Cut the cable to the required length (from the Beo Link
Active box to the receiver) and strip it as shown.
3 Insert the cable end through the cable clamp (E) and
connect the leads to the terminals inside the receiver in
the order indicated. Then tighten the clamp (E).
4 Attach the rear cover again and fasten the BeoLink
Active receiver to the wall (see page 4).
5 Plug the cable into the socket marked IR on the
BeoLink Active box.
Connect the leads in the receiver
cable to the terminals inside the
receiver in this order:
1 = Yellow
2 = Grey
3 = Green
4 = White
5 = Brown NOTE! Disconnect your entire
Bang & Olufsen system from the
mains while you make the
connections!
35 mm -
1
1
/
2
"
5 mm - 1 /
4
"
C O N N E C T I O N S
C
C
D
D
E
1
2
3
4
5
Strip the cable end. Twist the
cores in each lead and bend
them back.
>