Bang & Olufsen BeoLink Active - Setting-up Guide - Manual (Page 8)

8
When you have made all the connections as described in
the previous chapter you may start using the system.
However, in order for your setup to function properly, you
may need to preprogram it.
Your BeoLink Active can be preprogrammed for the
following setup situations (Options):
Option 0: To be used if you want to disable remote
control operation of the BeoLink Active (to re-enable
remote control, select one of the other options).
Option 4: To be used if you install the BeoLink Active in
the same room as your main system (e.g. in a large
L-shaped living room with two separate listening
positions).
Option 5: To be used if you install a TV set in the same
room as your BeoLink Active.
Option 6: To be used for a setup with the main system in
one room and the BeoLink Active in another, as described
in this guide.
NOTE! To ensure correct function
of your setup, it is essential that
you connect both the main system
and the speakers to the mains –
before connecting the BeoLink
Active box to the mains!
Using a Beo6:
> While holding the • button,
press the centre button to
bring up the SETUP menu on
Beo6.
> Let go of both buttons.
> Press Option Pgm to bring up
the Option Programming
display on Beo6.
> Press the button that matches
the zone in which
the BeoLink Active is placed.
Using a Beo4:
> While holding the • button,
press LIST on Beo4.
> Let go of both buttons.
> Use the navigation button up
or down to bring up
OPTION? in the Beo4 display
and press the centre button.
> Use the navigation button up
or down to bring up L.OPT in
the Beo4 display and press
the appropriate number
(0, 4, 5 or 6).
The preprogramming is done with a Bang & Olufsen
remote control, and must be carried out with both the
main and link system switched to stand­by!
R E A D Y F O R U S E …