Bunn FCD-4 - Manual (Page 9)

9
INITIAL FILL (cont)
Ambient Concentrates (Optional)
1. Install an Ambient Concentrate Conversion Kit (BUNN-O-MATIC part number 33699.0000) per the instructions
provided in the kit.
2. Attach the concentrate product hose to the appropriate concentrate line located behind the dispenser’s splash
panel.
3. Attach the other end of the product hose to the product container through an appropriate fitting.
PRIMING
1. Open the dispenser door
2. Load concentrate per instructions in section titled
Loading .
3. Close the dispenser door.
Note: The dispenser will not operate with the door open.
4. Place a large container under the appropriate dispense nozzle.
5. Dispensers with Press and Hold Feature:
Press and hold the “Product Dispense Switch” Fig 5, until concentrate dispenses from the dispense nozzle.
Dispensers with Portion Control Feature:
Press and hold the “+/STOP Switch” Fig 6, until concentrate dispenses from the dispense nozzle.
Note: This may take several seconds, depending on the installation and programmed pump speed.
33496 011101