Step 8, Step 9, Igniter button cap – Brinkmann PROSERIES Pro Series 2500 User Manual

Page 24: Grill body door bracket

Advertising
background image

23

Note: When performing Step 8, Lift

grill body from front and rear
panels to avoid injury to
hands and fingers.

Step 8

With the help of a friend, place grill
body assembly on grill cart. Grill
body will rest on upper side
sections of cart. Align bolt holes
located on the outside of the grill
body assembly. Secure using four
M6 X12mm bolts. At this point, fully
tighten four bolts holding back
panel from Step 6.

Note: To install battery, unscrew

igniter button cap. Insert
battery with positive end
towards button. Replace
igniter button cap.

Step 9

Install door bracket using four
M6 X 12mm bolts. Make sure door
stop is set toward back of cart.

1. Read and follow all warnings and instructions

in owner’s manual before lighting.

2. Open lid before lighting burner.
3. Make sure all control knobs are in the OFF position.
4. Select the burner to be lit. Push and turn the control

knob of that burner to HIGH.

5. Press the electronic igniter and hold for 3-5

seconds to light burner.

6. If burner does NOT ignite immediately, turn control

knob to OFF, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.

7. Repeat Steps 4-6 for lighting each burner. Always

use electronic igniter for lighting each burner.

8. Refer to owner’s manual for match lighting procedure.
9. For assistance, call 1-800-527-0717.

10. To turn off, turn control knobs clockwise until it locks

in OFF position.

GRILL LIGHTING INSTRUCTIONS:

FOR OUTDOOR USE ONLY

Igniter Button Cap

OFF

HIGH

HIGH

HIGH

LOW

LOW

LOW

LOW

LOW

LOW

HIGH

HIGH

HIGH

OFF

OFF

OFF

OFF

OFF

HIGH

HIGH

LOW

LOW

LOW

LOW

HIGH

HIGH

OFF

OFF

OFF

1. Read and follow all warnings and instructions

in owner’s manual before lighting.

2. Open lid before lighting burner.
3. Make sure all control knobs are in the OFF position.
4. Select the burner to be lit. Push and turn the control

knob of that burner to HIGH.

5. Press the electronic igniter and hold for 3-5

seconds to light burner.

6. If burner does NOT ignite immediately, turn control

knob to OFF, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.

7. Repeat Steps 4-6 for lighting each burner. Always

use electronic igniter for lighting each burner.

8. Refer to owner’s manual for match lighting procedure.
9. For assistance, call 1-800-527-0717.

10. To turn off, turn control knobs clockwise until it locks

in OFF position.

GRILL LIGHTING INSTRUCTIONS:

FOR OUTDOOR USE ONLY

Grill Body

Door bracket

Advertising