Brinkmann PROSERIES Pro Series 2500 - Manual (Page 25)

Step 10
Insert right side door over lower
pivot (on bottom cart panel) then
align door with cart frame. Depress
spring pin located on top edge of
door and slide door toward side cart
panel until spring pin locks into hole
in door bracket. Repeat for other
door.
Step 11
Attach side burner assembly to grill
body assembly by inserting four
M6 X 20mm bolts halfway into the
screw holes of the grill body
assembly. Then slide side burner
assembly onto bolts and secure all
four bolts. Install side burner grate
and control knob.
24
Screw Holes
Side burner grate
MAXIMUM SIDE BURNER LOAD = 15 lbs.
1. Read and follow all warnings and instructions in owner’s manual before lighting. 2. Open lid before lighting side burner.
3. Make sure all control knobs are in the OFF position.
4. Push and turn side burner control knob of that burner to HIGH.
5. Press the electronic igniter and hold for 3-5 seconds
to light burner.
6. If burner does NOT ignite immediately, turn control knob to OFF, wait 5 minutes to allow gas to dissipate and repeat
lighting procedure.
7. Refer to owner’s manual for match lighting procedure.
8. For assistance, call 1-800-527-0717.
9. To turn off, turn control knob clockwise until it
locks in OFF position.
SIDE BURNER LIGHTING INSTRUCTIONS:
Spring Pin
Lower Pivot