Troubleshooting, Red detection led remains on – Bendix Commercial Vehicle Systems BLINDSPOTTER INSTALLATION GUIDE User Manual
Page 20
18
Troubleshooting
Red Detection LED Remains On
If after the initial fi ve second system power-up test, the red detect indicator remains
illuminated constantly, even when no objects are present in the radar sensors
detection zone, either the radar sensor is improperly mounted or has malfunctioned.
1. Review the sensor installation section in this manual to verify proper sensor
positioning, orientation, and mounting.
2. Make sure there are no other surfaces or objects on the vehicle, like steps, fuel
tanks, mirrors, that extend beyond the face of the radar sensor that may be
interfering with the sensor's operation.
3. Remove the sensor from the vehicle and inspect it for any damage. Inspect the
connector for any signs of damage or corrosion.
4. Connect the sensor to the harness and hold it away from the vehicle into an
open area away from any objects. Power up the system and check for proper
operation.