Bendix Commercial Vehicle Systems BLINDSPOTTER INSTALLATION GUIDE - Manual (Page 21)

19
Troubleshooting
No Objects Detected
If after the initial system power-up the sensor does not appear to detect any objects,
the radar sensor may have malfunctioned. Refer to the Testing System Operation
section in this manual.
1. Hold and aim a test object six (6) feet out from center, directly at the sensor,
and verify if the side object display indicates the object has been detected.
2. Continuing to hold the test object six (6) feet from the sensor, refer to the
diagram below and move six (6) feet to the right and then to the left of center
from the sensor, keeping the test object positioned directly at the face of the
sensor. Verify if the side object display indicates the object has been detected
in both extreme positions.
3. Hold and aim the test object ten (10) feet out from center, directly at the sensor,
and verify if the side object display indicates the object has been detected.