Prepare the hood – Broan EVOLUTION QP236WW User Manual
Page 4
MODELS QP230BC • QP230BL • QP230SS • QP230WW
QP236BC • QP236BL • QP236SS • QP236WW
QP242BC • QP242BL • QP242SS • QP242WW
Page 4
8
NON-DUCTED INSTALLATION ONLY:
From parts bag: Attach
Non-Duct Diverter to Air Box
with 2
Screws and 2 Washers.
11
NON-DUCTED INSTALLATION ONLY:
Purchase a set of (2) non-ducted filters for 30” wide hoods
(Model BPPF30) & 36” wide hoods (Model BPPF36) or
a set of (3) non-ducted filters for 42” wide hoods (Model
BPPF42) from your local distributor or retailer. Attach the
non-ducted filters to the aluminum mesh filters following
instructions packed with the non-ducted filters.
FOR NON-DUCTED INSTALLATIONS - Skip to “INSTALL
THE HOOD”.
9
NON-DUCTED INSTALLATION ONLY:
Remove 2
Screws holding Non-Duct Plate to Non-Duct
Plenum and remove plate.
10
NON-DUCTED INSTALLATION ONLY:
Insert short end of
Non-Duct Plate into Non-Duct
Plenum
Slot. Attach with 2 Screws removed in Step 9.
SCREWS
SCREWS
NON-DUCT
PLATE
NON-DUCT
PLENUM
NON-DUCT
PLATE
ç
SLOT
7
Remove 2
Screws holding Damper / Duct Connector
to hood. Remove damper/duct connector from inside the
hood.
FOR DUCTED INSTALLATIONS - Skip to Step 12.
DAMPER /
DUCT CONNECTOR
6
Remove 6
Screws holding Bottom Pan to hood. Set bot-
tom pan and screws aside.
PREPARE THE HOOD
5
Remove the
Aluminum Filters
from the hood.
4
Remove all
protective polyfilm
from the hood
(stainless steel
hoods only).
3
Remove parts bag
from inside the
foam packaging
end cap.
ALUMINUM
FILTERS
ç
(1)
PULL
DOWN
(2)
LIFT
OUT
ç
NON-DUCT
PLATE
NON-DUCT
DIVERTER