Bird Technologies SH-362S-Manual - Manual (Page 44)

22
7. In the Measurement menu, select the desired measurement.

"Spectrum Analysis Measurement" on page 84.

"Occupied Bandwidth Measurement" on page 85.

"Channel Power Measurement" on page 87.

"Adjacent Channel Power Measurement" on page 89.

"Time Domain (Zero Span)" on page 91.

"Field Strength Measurement" on page 92.

"Demodulate Signal" on page 93.

"Carrier-to-Interference Ratio" on page 94.

"Out-of-Band and In-Band, Out-of-Channel Spurious" on page 96.

"Water Fall" on page 72.
8. Turn on markers or limit lines if needed (see “Marker On / Off” on page 73
and "Limit Lines" on page 75).
9. Make a sweep.
10. In the File & Help Menu, press Quick Save Trace to save the data (see “File
& Help Menu” on page 77).
Global Positioning System (GPS)
Note: Only firmware version 1.2.01302009 or higher will support the
GPS sensor. To get the latest firmware, refer to "Upgrading the Soft-
ware/Firmware" on page 131.
A Bird Electronic Compact GPS Sensor can be connected to the COM1 serial port
located on the back panel. It is used to record geographic position information
associated with a trace.
GPS status is indicated by an icon in the upper right corner of the display as fol-
lows:
Adding Custom Locations
See “Customizing SignalHawk Content” on page 129.
Icon Status Recording Action
None No GPS data is being received. No geographic position is saved
with the trace.
GPS data is being received;
however, there is no positional fix. No geographic position is saved
with the trace.
A positional fix is available from the
GPS.
The entire GGA message
(essential fix data which provides
3D location and accuracy data) is
recorded in the saved trace file.