Breadman BREAD BAKER TR444 - Manual (Page 13)

10
STEP 9
When your bread is done, the
Breadman
® will beep. This indicates that
the Baking phase is completed. Press the
STOP
Button, then put on your oven
mitts and remove the Bread Pan.
Remember that the Bread Pan and your
loaf are both very hot! Be careful not to
place either on a tablecloth, plastic
surface, or other surface that might
scorch or melt.
For all Cycles except Dough:
If the bread is not removed immediately
after baking and if the STOP Button is
not pressed, a controlled Keep Warm
Cycle will begin and the machine will
automatically shut off after 3 hours.
While this will help prevent the bread
from becoming soggy, for best results,
remove bread immediately after the
Baking Cycle is complete.
STEP 10
Remove the loaf from the Bread Pan.
Turn over the Bread Pan a few inches
from the countertop and gently shake out
the loaf. It’s best to remove the loaf as
soon as the machine is done baking.
Place the loaf on a wire rack or other
ventilated cooling surface to cool. Bread
should be cooled slightly (30 minutes)
before it is sliced.
If necessary, remove the Kneading
Paddle from the loaf.
Sometimes the Kneading Paddle will stick
in a loaf of bread. If it does, use a non-
metal utensil to gently remove it, taking
care not to scratch the Kneading Paddle.
When you are done using the Breadman ® ,
be sure to unplug it.
You can preset your Breadman ® to cook bread from 4 hours to
13 hours in advance.
Note: Do not use the Delay Timer if your recipe includes
eggs, fresh milk or other ingredients that may spoil.
To preset your Breadman ® , follow these steps:
1. Add your ingredients as usual , taking care not to let the
yeast and liquid ingredients contact one another.
2. Close the Breadman ® Lid and plug it in.
3. Press the SELECT Button for the Baking Cycle you
prefer as well as the CAPACITY/LOAF SIZE Button for
the size loaf you wish to bake.
4. Press the TIMER SET Button once for each 10 minutes
you want to add.
The amount of time set is shown in the Display Window.
Note: To fast forward time, continually press the
TIMER SET
Button.
For example, if it is 8:00 PM and you want a loaf of bread
ready at 7:00 AM, that is 11 hours from now, press the
TIMER SET
Button until 11:00 appears on the Display.
5. Press START Button to begin the Timer. The colon (: ) in
the Display Window begins to flash, letting you know the
Timer is started.
6. If you make an error after you have activated the
Timer and want to start over, press STOP and you can
begin again.
11
USING THE TIMER
TR444 OM REV 899 9/16/04 8:29 AM Page 9