Bird Technologies ACMI - Manual (Page 34)

22
Factory Defaults -
Use the Factory Defaults button to clear all alarm settings
and return the alarm configuration to factory default conditions (Latch Alarms
and VSWR Alarm Enable checked, VSWR Trip Point =1.8).
Figure 13 WebTool Config Screen, Alarms
Admin Screen
The Admin screen has four tabs, Network, Email Alerts, SNMP, and Passwords.
After making changes in one or all of the tabs, click the Apply All Changes button
to record your settings in memory.
For more information about the Admin screen, refer to the help in the software
(click on the Help button).
Network Tab
In the Networking tab (Figure 14 on page 23), you can specify the following infor-
mation about the address of the ACMI: IP address, subnet mask, gateway IP,
DHCP host name, and whether or not DHCP is used.
An IP address is required even if you connect the BPM-E directly to a computer
that is not on a network. Contact your IT professional for assistance in determin-
ing the IP address, subnet mask, and information about DHCP use and name.