Blackline GPS Dart - Manual (Page 14)

12 // User GUide
Charging Dart
Charging status can be determined by observing the Red Charging Light. See the section
Red Charging Light for more detailed information.
1. Plug the wall charger into an electrical outlet (some outlets are controlled by a
wall switch).
2. Remove the Sealing Plug from the Micro USB Charging Port on Dart.
3. Insert the Micro USB Cable Plug into the corresponding Micro USB Charging Jack
on Dart ensuring the USB symbol on the cable faces the bottom of Dart.
4. Completely charge Dart for 8 hours.
5. Remove the power cable from Dart and replace the Sealing Plug.
™ If Dart is in a very low power state, it may take up to an hour of charging before the
charging state can be observed.
™ Dart is environmentally protected only when the Sealing Plug is fully inserted into the
charging port.
Turning Dart On
1. Press the Power/Status button to turn Dart on.
2. Dart will attempt to connect to a wireless network.
™ There is an approximate two second delay from when the button is pushed until the
Green Status Light is powered.
™ Dart needs to have sufficient battery power to connect to the wireless network. It takes
approximately one minute for Dart to connect to the wireless network.
Turning Dart Off
1. Press the Power/Status button once to wake up the Green Status Light
Stealth Mode.
2. Press the Power/Status button for four seconds to power Dart off.
™ Dart will flash both the Green Status Light and the Red Charging Light while turning off
during the shutdown sequence.