Blakeslee DD-8 - Manual (Page 3)

— 3 —
WARNING : Before performing any service that involves electrical
connection or disconnection and/or exposure to electrical components, always
perform the Electrical LOCKOUT/TAGOUT Procedure. Disconnect all circuits. Failure
to comply with this procedure can cause property damage, injury or death.
WARNING : Before removing any sheet metal panels, always perform the
Electrical LOCKOUT/TAGOUT Procedure. Be sure all circuits are disconnected.
Failure to comply with this procedure can cause property damage, injury or death.
WARNING : Do not operate this equipment without properly placing and
securing all covers and access panels. Failure to comply with this procedure can
cause property damage, injury or death.
WARNING : Do not use or store gasoline or other flammable vapors or
liquids in the vicinity of this or any other appliance. Failure to comply can cause
property damage, injury or death.
WARNING : In the event of a power failure, do not attempt to operate this
appliance. Failure to comply can cause property damage, injury or death.
ELECTRICAL LOCKOUT/TAGOUT PROCEDURE
WARNING
Before performing any service that involves electrical
connection or disconnection and/or exposure to
electrical components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect all circuits.
Failure to comply with this procedure can cause
property damage, injury or death.
The Electrical LOCKOUT/TAGOUT Procedure is used to
protect personnel working on an electrical appliance.
Before performing any maintenance or service that
requires exposure to electrical components, follow these
steps:
1. In electrical box, place appliance circuit breaker into
OFF position.
2. Place a lock or other device on electrical box cover
to prevent someone from placing circuit breaker ON.
3. Place a tag on electrical box cover to indicate that
appliance has been disconnected for service and
power should not be restored until tag is removed
by maintenance personnel.
4. Disconnect appliance power cord from electrical
outlet.
5. Place a tag on the cord to indicate that unit has
been disconnected for service and power should
not be restored until tag is removed by maintenance
personnel.