Bulldog Security 1402 - Manual (Page 8)

‘ ‘
‘ ‘
CONNECTING THE CAR HORN WIRE
You must use optional part #775.
MOUNTING AND CONNECTING THE OPTIONAL SIREN
Select a location under the hood for the siren. For best results, the location
should meet the following conditions:
•The mounting location should be solid and have no moving parts nearby.
•For the loudest sound, the siren should point down.
•The siren should not point straight up as moisture could collect in the
siren horn and damage the system.
•To prevent water damage, the siren should NOT be mounted in a wheel
well, directly behind the radiator grill or close to the ground.
•Mount the siren as far away from sources of heat, i.e. exhaust manifold,
turbo charger, etc. as possible. Tape, wrap or tube all wires. Run all
wires to the siren as high up in the engine compartment as possible to
prevent cutting from below.
15
LOCATING & MAKING
CONNECTIONS
CONT.
86 85
87
30
87a
BLUE
BLACK
YELLOW To (-) horn
wire in vehicle
RED
Not used
To (+) horn
honk output
wire from unit
BLACK/BLUE
WHITE
Back of #775
(relay and harness)
Using the siren base as a template, mark the three mounting holes.
Drill a 1/8 inch hole at each mounting hole location, taking care not to
damage anything behind the mounting surface.
Secure the siren to the mounting location with two of the mounting
screws.
Connect the wires as shown.
16
LOCATING & MAKING
CONNECTIONS
CONT.
BLUE PLUG
LED
INDICATOR
GROUND
OVER-
RIDE
SWITCH
WHITE
PLUG
22 GA BLACK WIRE WITH GREEN TAG
(Shock or microwave sensor - negative
input), optional accessories required
MOUNTING AND
CONNECTING THE
OVERRIDE SWITCH
Select a location for the
override switch. You
should be able to reach
the switch when sitting
in the driver’s seat, but
the switch should be
hard to find. A typical mounting location is under the dash. The
mounting surface should be less than 1/8 inch thick.
BLACK/BLUE RED
BLACK