Blizzard Lighting 5 ToughStick (Rev A) - Manual (Page 12)

Page 12
ToughStick™ 5 User Manual Rev. A © 2013 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
d001
on the LED readout. To
select a different DMX address, using the <MENU> button, select
Addr
,then hit <ENTER>.
Use the <UP/DOWN> buttons to select the correct address, then hit <ENTER> to confirm.
Setting the DMX Channel Mode:
1.) To select a DMX channel mode, press the <MENU> button, then use the <UP> or
<DOWN> buttons until the display reads
Chnd
and press the <MENU> button. Then use
the <UP> or <DOWN> buttons until the display reaches your desired channel mode. Press the
<MENU> button to confirm.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
1.) To set the fixture in Flash/Fade mode, select
FLAS or FAdE
. To confirm, press the
<ENTER> button.
2.) Now, you can adjust the flash settings from
FL00-FL15
or the fade settings from
FA00-FA15.
Then press the <ENTER> button to confirm.
3.) To use the fixture in automatic mode, select
ASC-
, and press the <ENTER> button. Then
use the <UP/DOWN> to choose from
AS00-AS15
, then press the <ENTER> button to
confirm.
4.) Adjust the speed of the chase as above using
SP15
(slowest) to
SP00
(fastest) then
press the <ENTER> button to confirm.
5.) To set the fixture as a slave unit, select
SLAU
, and hit <ENTER>. The unit will display a
flashing
SL.AU
to indicate it is in slave mode.
Sound Active Mode:
1.) To use sound active mode, select
SouA
, then press the <ENTER> button to confirm.
Standalone (Program) Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To set the fixture in manual mode, select
Pr--
.
To confirm, press the <ENTER> button.
2.) Now, select the program by using the <UP> and <DOWN> buttons to select
Pr00-
Pr15
. To confirm, press the <ENTER> button.
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture. These settings are global, they will effect all
modes.
1.) Use the <MENU> and <UP/DOWN> button to select
rL--
(Red Level),
GL--
(Green
Level),
bL--
(Blue Level),
AL--
(Amber/UV Level), or
UL--
(White Level), then hit
<ENTER>.
2.) Using the <UP/DOWN> buttons, select the maximum level for each color between
x000-x255
(000=off), then hit <ENTER> to confirm.