Blomberg GSN 9477 A - Manual (Page 29)

28 EN
YM_program_
takibi
Starting the programme
To start your machine after selecting
the programme and auxiliary functions,
press Start / Pause / Cancel key.
Once the programme starts to run,
Remaining Time indicator displays
the estimated time to the end of the
programme. Start / Pause indicator
starts lighting continuously.
C
Your machine performs water
softening depending on the
hardness level of the supply water.
Remaining time displayed towards
the end in some programmes can
be different from the time indicated
at the beginning due to this
process. The total time can also
change while the programme is
running depending on the ambient
temperature where your machine is
installed, temperature of the supply
water and amount of the dishes.
C
Pay attention not to open the door
of the machine when it is running.
Stop the machine by pressing Start
/ Pause / Cancel key if you have to
open the door. Then, open the door
of the machine. There may be a
rush of vapour when you open the
door of your machine; be careful.
Close the door of your machine
and press Start / Pause / Cancel
key again. Programme will resume
running.
Child Lock
You can prevent other people
from interrupting and changing the
programme cycle and delay time while
the machine is running.
1. Press and hold the Programme
Selection key and the Half Load
key simultaneously for three
seconds to activate the child lock.
Child Lock indicator will appear
on the display. Repeat the same
procedure to disable the Child
Lock.
C
Child lock prevents the selected
programme or functions from being
changed and disables the Start /
Pause / Cancel key.
C
Child Lock does not lock the door
of the machine.
Programme follow-up
You can follow-up the washing step
in which the current programme is in
from the Programme Steps Follow-up
indicators on the display.
a Washing Step indicator
b Rinsing Step indicator
c Drying Step indicator
d End of Programme indicator
Indicators for Washing, Rinsing and
Drying will light respectively on the
display while the selected programme
is running. Only the End of Programme
indicator lights up when the
programme is over. “00:00” appears on
Remaining Time indicator.
Canceling a programme
1. Press and hold Start / Pause /
Cancel key for 3 seconds while the
programme is running.
2. Release the key when the Start /
Pause indicator starts flashing.
For a couple of minutes the
� � � �
��