Blomberg GSN 9477 A - Manual (Page 40)

39 EN
Detergent remains in detergent dispenser.
• Detergent dispenser was damp when adding detergent. >>> Make sure that
the detergent dispenser is dried well prior to filling it with detergent.
• Detergent is added long before the washing process. >>> Pay attention to
add detergent shortly before start-up of the washing.
• Opening of the detergent dispenser lid is prevented during washing. >>>
Place the dishes in a way that will not prevent the detergent dispenser lid
from opening and the water going into the machine from impellers.
• Detergent is stored under unsuitable conditions. >>> If you are using powder
detergent, do not store the detergent package in humid places. Keep it in a
closed container if possible. For ease-of-storing, we recommend you to use
tablet detergents.
• Impeller holes are clogged. >>> Lower and upper impeller holes might
be clogged with food remnants such as lemon pips. Clean the impellers
regularly as illustrated in section "Cleaning and Care".
Decorations and ornaments on kitchen utensils are being erased.
C
Decorated glasses and decorated luster porcelains are not suitable for
washing in the dishwasher. Manufacturers of glassware and porcelain
tableware items do not recommend washing such kitchen utensils in the
dishwashers either.
Dishes are scratched.
C
Kitchen utensils that contains or are made of aluminum should not be
washed in dishwasher.
• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling
hole while adding salt. Spilled salt can cause scratches. Make sure that
the salt reservoir lid is tightly closed after finishing the filling process. Run
the prewash programme to remove the salt that spilled inside the machine.
Since the salt granules that will remain under the lid will dissolve during
prewash, causing the lid loosen, check the lid once again at the end of the
programme.
• Water hardness setting is low or salt level is insufficient >>> Measure the
hardness of the supply water appropriately and check the water hardness
setting.
• Dishes are not placed orderly in the machine. >>> When placing the glasses
and other glassware into the basket lean them not against other dishes but
the edges or racks of the basket or the glass support wire. Striking of the
glasses to each other or to other dishes due to the impact of water during
washing can cause breaks, or scratches on their surfaces.