Blomberg TKF 7431 A - Manual (Page 59)

59 EN
program knob. Press “Start/Pause/Cancel”
button to start the program.
C
If you select a new programme by turning
the programme selection knob while
your machine is running, then the current
program is cancelled and new programme
information is displayed.
Adding/removing laundry in
standby mode
In order to add or take out laundry after the
start-up of the programme;
1. Press the “Start/Pause/Cancel” button
to switch the machine to “Pause” mode.
Drying process will stop.
2. Open the door at Pause position and close
it again after adding or taking out laundry.
3. Press “Start/Pause/Cancel” button to start
the program.
C
Any laundry added after the drying process
was started may cause the already dried
clothes in the machine intermingle with wet
clothes and the result will be wet laundry
after the drying process is over.
C
Laundry may be added or taken out as
much as desired during a drying process,
but as this process will interrupt drying
continuously, it will extend the program
duration and increase energy consumption.
Therefore, it is recommended to add
laundry before the drying programme has
started.
C
If you select a new programme by turning
the programme selection knob while your
machine is in standby, then the current
program is cancelled and new programme
information is displayed.
Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing of
button while the programme is running. The
loading door and all button except the “On/Off”
button on the panel are deactivated when the
child-proof lock is active.
In order to activate the child-proof lock, press
on the “audio warning” and “anti-creasing”
buttons simultaneously for 3 seconds.
To start a new programme after the
programme is over or to interrupt the
programme, the child-proof lock should be
deactivated. Press the same buttons for 3 sec.
again to deactivate the child-proof lock.
Lock symbol will appear on the screen when
the child-proof lock is activated.
C
Child-proof lock will also be deactivated
when the machine is restarted by pressing
the on/off button.
When the child-proof lock is activated:
• Display icons will not change even if the
position of programme selection knob is
changed while the machine is running or in
halt.
• If the child-proof lock is deactivated after
changing the position of the programme
selection knob while your machine is
running, your machine stops and new
programme information is displayed
Ending the programme through
canceling
A new program can be selected and started
after “Program cancel” is activated in order to
change the drying program.
To cancel any selected programme:
Press “Start/Pause/Cancel” button for about
3 seconds. “Lint filter cleaning” and “Water
tank” warning symbols light up and “End” label
appears on the screen as a reminder at the
end of this period.
A
As the inside of the machine will be
excessively hot when you cancel the
program while the machine is running,
activate the ventilation program to cool it
down.
C
If you change the position of programme
selection knob while your machine
is running, then the machine stops,
current programme is cancelled and new
programme information is displayed.