BLUESHAPE MVQUICK Hot-Swap adapter - Manual (Page 5)

5
This automatic partial charging is an efficient way to keep
MVQUICK fully charged even after several swaps.
It is however recommendable to fully charge MVQUICK on a
charger for the first time, or prior to an extensive working session.
How to switch off / switch on
MVQUICK is supplied switched off to save internal power and
automatically enters in low power mode when not in use.
- How to switch it on:
a) MVQUICK automatically switches on upon installation of an
external battery with a voltage > 12V. Note that when an
external battery is installed, MVQUICK is permanently on and
will never enter in low power mode.
b) By pressing the LED button to check the state, when an
external battery is not installed.
- How to switch it off:
a) MVQUICK automatically switches off when an external
battery is not installed for at least 60 minutes and the LED
button is not pressed during this period.
b) To force a switch off, remove the external battery and press
and hold the LED button for about 5 seconds until the LEDs go
off.
When MVQUICK is operating as the only power source, regardless
whether it is powering a device or not (meaning that no external
battery is installed), it will switch off after 60 minutes. To avoid this,
just press the LED button once to restart the countdown and prolong
the operating period.
It is preferable to switch off MVQUICK after a working session or
before storage to minimise the power consumption and the self-
discharge.