Brandmotion 9002-8525 - Manual (Page 5)

INSTALLATION
INSTRUCTIONS
INSTALLATION
INSTRUCTIONS
8525 Instructions 7-18-13.doc Page 5 of 5
Step 20: Connect Mirror Harness as follows:
Red - Ignition controlled power 12v+ when key is
turned ON and 14.4v or better when vehicle is
running.
Black - Ground (Recommended: Add an Eyelet and
secure to chassis with a sheet metal screw or
with a nut on an existing stud.).
Green - Connect to Reverse + power (reverse lamp)
(Recommended: Solder & cover with Heat
Shrink Tubing or T-taps as optional connection
method)
Mirror Voltage Requirement:
The mirror must see a voltage of 12.5 DC or
better on the Reverse trigger lead. In the
event that the signal is too low the signal
quality may be affected drastically when the
vehicle is running.
In order to correct this, Reverse voltage must be
raised using a Single Pull Dual Throw Relay.
Relay Wiring
30 To Mirror Reverse trigger (Green lead)
85 Chassis Ground (–)
86 Reverse trigger from vehicle (reverse lamp)
87 High current Ignition controlled power lead (+)
87a Not used
Connect rest of the mirror harness as indicated
in Step 20.
For Ford vehicles only: If the vehicle has a
separate display on the instrument panel for
the compass and it displays – – after the OE
mirror is removed you must follow online steps
in Section 6 of instructions 1008-9520 in order
for it to function again.
Step 21: Isolate individually any unused Red,
Green, or Black wires of the Mirror Harness with
Electrical Tape.
Step 22: Connect Chassis Harness to supplied
Mirror Harness.
Step 23: Test system. Inspect that all
connections are proper and secure. Clear all loose
items removed from the area around the vehicle
and turn ignition key ON to test system. Once
reverse gear is engaged the camera image should
appear on the Mirror.
Step 24: Secure Chassis Harness and Mirror
Harness with supplied Wire Ties. If necessary,
coil excess harness wire and secure with Wire Ties.
Attach to existing vehicle wiring where possible.
Step 25: Adjust camera aim. With the aid of an
assistant, move Camera to desired view, and
tighten the screws that hold the Camera in place.
Step 26: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling
OPERATING
INSTRUCTIONS
Temporary Monitor Manual Shut Down. If while in reverse you require to turn OFF the camera
monitor, simply press and release the POWER button on the Mirror. (Note: Once reverse is disengaged
Mirror will resume normal operation and will turn ON the next time reverse is engaged).