Brandmotion 1022-9590 - Manual

INSTALLATION
INSTRUCTIONS
9581 Instructions 4-18-13.doc 1 of 13
Rear Vision System
2009 – 2012 Chevrolet Traverse
(Kit part numbers 1022-9581 through -1022-9590)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Camera Handle with harness in bubble bag
Chassis Harness
1 bag containing:
10 Wire Ties
Brown Wire with terminal
(for factory NAV installs only)
White Wire with terminal
(for factory NAV installs only)
1 bag containing:
These instructions
Handle surround foam gasket
(Kit #1022-9581 only)*
Camera foam gasket
(Kit #1022-9581 only)*
*To be added to primed handle after painting.
Tools & Supplies Needed:
T15 and T40 Torx Drivers
7mm and 10mm Sockets
Push Pin Removal Tool
Pick Tool
Plastic Trim Tool
Electrical Tape
Fish Tape or 1’ Wire Tie
Soldering Iron
(Recommended)
Heat Shrink Tubing
(Recommended)
Additional Tools Required for Optional
Mirror Install:
T20 Torx Driver
Wire Pick Tool
Delphi Terminal Tool 12094429 (or Small Flat
Blade Watch Repair Screw Driver & Push Pin)
Multimeter
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
TABLE OF CONTENTS
Kit Installation to Aftermarket Display with RCA Input Steps 1 – 48
Kit Installation to Mirror with 16-pin connector* Steps 1 – 45 and Steps 49 – 80
Kit Installation to Factory NAV Steps 1 – 45 and Steps 81 – 86
*This option requires purchasing Brandmotion kit number 9002-9510.