Brandmotion 1022-9590 - Manual (Page 8)

INSTALLATION
INSTRUCTIONS
9581 Instructions 4-18-13.doc 8 of 13
Step 41. Remove left lower A-pillar ground bolt using a
10mm socket.
Step 42. Attach Chassis Harness ground eyelet (on the
Black wire) to the stud and reinstall the bolt with socket.
Step 43. Splice Red wire from Chassis Harness to the
Yellow wire in cavity 2 of the Gray BCM X7 connector
(Figures 10, 11 & 12). Solder the connection and cover
with Heat Shrink Tubing or Electrical Tape.
Figure 10
Figure 11
Figure 12
Body Control Module (BCM) X7 Connector
Step 44. Splice Green wire from Chassis Harness to the
Light Green wire in cavity 2 of the Pink BCM X6
connector (Figures 10, 11 & 13). Solder the connection
and cover with Heat Shrink Tubing or Electrical Tape.
Figure 13
Body Control Module (BCM) X6 Connector
Step 45. Connect Chassis Harness to the female RCA
jack of your aftermarket video display. If connecting to a
16-pin display mirror, follow Steps 49 -80. If connecting
to a factory NAV system, follow Steps 81 - 86.
Step 46. Test the system. Inspect that all connections
are proper and secure. Clear all loose items removed
from the area around the vehicle and turn ignition key
ON to test system. Once Reverse gear is engaged the
camera image should appear on the display or mirror.