BT classic 1100 Executive - Manual (Page 28)

On-Air 1100 Executive user guide ~ Edition 5.1 ~ 4.7.00
28
Wall mounting
2
122 mm
WALL
WALL PLUG SCREW
122mm
If wall mounting your BT On-Air 1100
Executive, use this guide for position.
• Make sure that you are not drilling into any
hidden wiring and check that the power
cable will reach from the mains socket to
the charger. Switch the power adaptor off at
the mains and remove the adaptor plug
from its socket.
• Drill two holes 25mm deep using a 3mm
drill, 122mm apart to take the wall plugs.
• Put wall plugs into the drill holes and then
insert both screws. Leave 2-3mm between
the head of the screw and the wall. You are
now able to mount the base to the wall.
• Fit the base onto the two screws.
If necessary, tighten or loosen the screws
for the best fit.
• Put the handset back in the base and switch
the power back on at the wall socket.
Once slotted into the rear
of the base, slide upwards
to lock into position. 1 Push the base-mount
forward onto the rear
of the base.
On-Air 1100 Executive 4/7/00 1:48 pm Page 28