Parts & service troubleshooting – Brew Express BE-110 OPERATION GUIDE User Manual
Page 13
Cup or mug not detected (flashing brew light)
• Mug not close enough to detect sensor (move further into brewer).
Water dripping from spray head
• Normally some water will drip from the spray head shortly after brewing.
• Debris may be inside valve. Disconnect water and reconnect, then run 1-2 full cycles of water in carafe.
If problem persists, contact customer service.
Programmed start time not working properly
• Review instructions on page 6 (Automatic Brew Cycle).
Spare parts are available from Brew Express (866) 268-5953 or [email protected]
Contact Brew Express for all service and warranty issues.
• Spray head
• Brew Baskets (flat bottom and cone)
• Carafe and lid
• Mounting screws
• Auxiliary water pump (for installation in areas without water supply)
• Water filter / replacement filter cartridges)
11
PARTS & SERVICE
TROUBLESHOOTING