Brew Express BE-112 OPERATION GUIDE - Manual (Page 6)

IMPORTANT:
Please read and follow instructions carefully before starting your BREW EXPRESS™
in-the-wall COFFEE SYSTEM.
Did you purge water lines during installation to remove any foreign particles (debris) in lines?
Debris in water lines can clog brewer system causing failure, and VOID ALL WARRANTIES.
The BREW EXPRESS™ dispenses extremely hot water. Hot liquids may cause severe burns if it contacts skin. Use ex-
treme caution when handling hot liquids dispensed by the BREW EXPRESS™. KEEP HANDS AWAY FROM SPRAY HEAD,
BREW BASKET, CARAFE OR MUG DURING BREW CYCLE.
1. Make sure water is “ON” prior to starting BREW EXPRESS™. The BREW EXPRESS™
will not operate if there is no water or water pressure is less than 30 psi.
2. Make sure power is supplied to the BREW EXPRESS™. Power is supplied when the LED
display is illuminated on the display panel.
3. With the selector switch OFF, set clock by holding down buttons to advance hours, minutes
noting the AM/PM indicator light.
4. Flush brewing system by running two cycles of water through the brewer. Place brew basket under spray head without
coffee or filter, place empty carafe under brew basket, select a full carafe, and move the switch from OFF to ON. After
brewing cycle is complete, empty carafe and repeat.
5. Wash carafe and brew basket with warm soapy water.
IMPORTANT REMINDERS
• Always empty carafe prior to starting the unit, otherwise overfilling can occur.
• Use appropriate brew basket with carafe and mug.
4
START UP