Brew Express BEC-110 OPERATION GUIDE - Manual (Page 7)

5
SET UP
5
SET UP
!
!
water line to sink
¼” poly water line
to coffee maker
cold water
valve
angle stop
valve
adaptor
Option 1: Cold Water Tap
water line
to ice maker
¼” poly water line
to coffee maker
Option 2: Ice Maker Line
cold water line
!
!
• connection to water supply (supplied)
• remove water line from valve to facet
• add valve
• reconnect facet line to tee hardware
• connect new ¼” poly line to valve connection
• Valve connection included
• cut existing line from house interior wall where water line starts and runs
to refrigerator. Do Not cut line located on the refrigerator. If line is not ¼”,
then refer to note below for additional information on obtaining parts to
connect. You may also contact us directly at [email protected]
• add valve
• connect new ¼” poly line to tee
PLEASE NOTE:
If you have a ¼” compression waterline connection and you are not able to simply cut and use the enclosed T part, you can
use the supplied 3/8” John Guest Valve with adapter parts (not supplied). Basically by adding the following parts to the 3/8”
John Guest valve it will allow you to connect to a braided style ¼” compression line that is connecting to your refrigerator. The
following parts can be found at most home improvement big box stores.
1. Watts: LFA-157 - Compression adapter (3/8” OD x 1/4” female OD)
2. Watts: LFA-109 - Ander-lign Compression Union (3/8” OD by 1/4” OD)
3. Anderson-Barrows 12” Filter supply line 1/4’ compression to 1/4” compression
3. Connect water line to water source.
A. Water source options are typically the cold water tap under the sink or the water line connecting to the refrigerator ice
maker. DO NOT connect directly to ice maker line located on refrigerator.
B. If connecting to refrigerator supply Brew Express provides a ¼” T to connect to the ¼” line. Sometimes this supply line may
be a compression braided line. If so, it may require additional parts (not supplied). Please contact Brew Express for advice,
or additional notes below Option #2.
C. Do not connect to dishwasher line.
NOTE – shut off water sources before removing or alternating existing lines.