Brew Express BEC-110 OPERATION GUIDE - Manual (Page 8)

recess tab
water line
compression nut
quick connector
!
cord recess
!
water filter recomended
(not included)
!
!
SET UP
6
Water filter recommended
(not included)
4. Run water line to brewer location.
A. Run water line behind cabinets through the wall to brewer area.
B. Run water line direct from source to counter top (for example along the side of the refrigerator).
5. Waterline connection to brewer
A. Cut waterline near final location of brewer.
B. Attached water line to quick connector (supplied).
• place compression nut onto water line
• slide water line onto barbed feature
• tighten compression nut (with wrench)
• note - quick connector has built in valve, water can now be turned on
C. Turn on water supply and check for leaks.
D. Snap quick connector into mating connector on rear of Brew Express unit. Make sure to listen for a “click/snap” noise.
This ensures the connection is completed.
•To release connection, press grey tab on connector.
6. Connect Power
Plug the power cord into an outlet.
Excess cord can be stored in the grey tab on the back of the Brew Express.
grey