brite-View Air Sync3D BVW-200 User Manual - Manual (Page 17)

16
No input from selected
source
(Note B)
Static Blue
Blinking
(Quickly)
Video format not
recognized
(Note C)
Static Blue
Blinking
(Slowly)
Wireless
linked
Mode
Video format is
recognized
Static Blue Static Blue
-
Note:
A. If the RF connection over 80sec and still not established, it might link lost or the transmitter is
most likely out of range. You may have to verify the range and adjust or shorten the distance
between your HDTV set with the transmitter and the receiver. The maximum video
transmission range for 1080p content is up to 66 feet in line of sight (LOS). < The minimum
range is 6.5 feet. >
B. Please make sure the source player have been power on and switched the signal output to
HDMI out; also try to re‐plug the HDMI cable to make sure the HDMI connector had settled
well.
C. If there is no video displayed and OSD displayed “Not Supported Format”, this is an indication
that the video frame rate from the computer is not supported, please refer chapter 5 to switch
a supported video timing.
D. If you have more than one pair of BVW‐200, each transmitter and receiver should be at least
6.5 feet away from one another. If both the transmitter and the receiver exist in the same room,
the suggested the distance between the two is 6.5 feet minimum.