Bully Dog 40630 CAT 3126, C7 and C9 engines - Manual (Page 10)

9
inSTAllATiOn
4. Plug the male OEM MAP sensor plug into
the female Module MAP sensor plug.
5. Plug the female OEM MAP sensor plug in
the male Module MAP sensor plug.
6. Locate the ICP Sensor: once located then follow the
connected wire harness to the triangle shaped plug set
and disconnect that plug set in preparation to tie in the
Bully Dog harness. The Injection Control Pressure sensor
is located on the right side of the engine near the front.
MAP w/ Rapid Power connected
Injection Control Pressure Sensor
Injection Control Pressure Sensor
Plug Set
L R
F B