Bully Dog 53105 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 9)

8
RFI COLD AIR INTAKE
Preparing the RFI Intake
1. Snap the Stage 1 RFI Tube into the RFI base.
2. Remove the MAF sensor from the stock intake tube.
(Use the T20 Torx® bit.)
3. Attach the MAF sensor to the Stage 2 RFI Tube.
a. Use the MAF Sensor Gasket.
b. Use one nylon washer and one black oxide screw on
each side.
IMPORTANT: Do not overtighten the screws, as this could damage the MAF sensor.